Iprodione 500SC
Area to use
For the control of certain fungal diseases in various crops and situations as specified in the Directions for Use table.
Active Constituent:
500 g/L IPRODIONE
Group 2 Fungicide
Imtrade Iprodione 500SC Fungicide is a member of the dicarboximide group of fungicides. For fungicide resistance management the product is a Group 2 Fungicide. Some naturally occurring individual fungi resistant to the product and other Group 2 Fungicides may exist through normal genetic variability in any fungal population. The resistant individuals can eventually dominate the fungal population it these fungicides are used repeatedly. These resistant fungi will not be controlled by this product or other Group 2 Fungicides, thus resulting in a reduction in efficacy and possible yield loss. Since the occurrence of resistant fungi is difficult to detect prior to use, Imtrade Australia Pty Limited accepts no liability for any losses that may result from the failure of this product to control resistant fungi
Mixing
Note: Imtrade Iprodione 500SC Fungicide may be unstable in conditions where the pH is 7 or higher. It is therefore essential to check the pH of the spray solution before adding Imtrade Iprodione 500SC Fungicide. A suitable registered buffering agent may have to be added to bring the pH down below 7. Add the required amount of Imtrade Iprodione 500SC Fungicide to the spray tank containing half the required volume of water. Mix thoroughly and make up to the required volume.
Application
Good disease control requires even, thorough coverage of the target area. Application should be made using appropriate spray equipment and sufficient water to provide adequate penetration and coverage. Equipment settings and water volume may need to vary, depending on the growth stage of the crop.
Packaging
5L – 1000L